The reason I wanted to use it is power consumption. I had previously planned to use 100BASE-T (normal 100Mbps ethernet) in a robotics project but it turns out that it uses about 0.8W per port (1.6W per cable) so it was using by far using more power than my various microcontrollers. Faster ethernet uses even more power. There is a standard for low power ethernet but it's not a huge improvement and you really have to go out of your way to select components to use it.
I ended up using CAN, but it will be really nice when these standards become well-supported.
IEEE802.3da is working to add PoDL on 10Base-T1.
object 9. Specify optional plug-and-play power distribution over the mixing segment
objective 10. PSE shall only energize the mixing segment when at least one PD is connected
objective 11. Support addition and removal of a node or set of nodes to a continuously operating powered mixing segment
Astonishingly, not only did it work the first time, it worked well enough to stream video. I'm hoping to see a more standardized PoDL interface crop up so that I can use two wires for data and power combined, for lower-power subsystems.
There's a lot of application for this standard, I hope it catches on enough that I can keep buying chips for it for a long time.