News for hackers. Stuff that matters.
Re:Update on Samsung SSD Reliability by dinvlad on Friday February 03, 2023 @08:49PM (#34650497)
Worth checking if you have any thermal issues with it. Mine failed in a similar way due to presumably a rookie mistake of forgetting to remove the thermal pad tape on the mobo.
Re:Update on Samsung SSD Reliability by jeffbee on Friday February 03, 2023 @09:17PM (#34650690)
It's not likely that thermal issues would cause bad reliability on these things. At worst you could expect intermittently bad performance. You can check for this condition with `nvme smart-log`. If your device was often overheated, it would have "critical composite temperature time" non-zero. My Samsung that has been in service for years and has no thermal solution has a value of 1 minute and I happen to know that is because I heated it with a hair dryer to find out what would happen if it crossed the critical temperature.
Re:Update on Samsung SSD Reliability by dinvlad on Friday February 03, 2023 @09:21PM (#34650708)
Ha, interesting! Makes sense, the drive is supposed to just throttle itself before it can reach unsafe temps. I’ll def try to check, didn’t know the drive recorded that - thanks for the tip. In any case, now I know RMA is in order
Re:Update on Samsung SSD Reliability by short_sells_poo on Saturday February 04, 2023 @05:13AM (#34653293)
"I happen to know that is because I heated it with a hair dryer to find out what would happen if it crossed the critical temperature."

Ah this is a fantastic and true hacker mindset :)

Willing to tamper with fairly expensive equipment just for the heck of it.

Re:Update on Samsung SSD Reliability by lobocinza on Saturday February 04, 2023 @10:04AM (#34654994)
The controller is less thick than the NAND flash so don't make proper contact with the thermal pad. I just discovered mine is affected by this. After heeavy reading the controller is at 67C while the NAND is at 42C.

https://www.youtube.com/watch?v=I8Z09nU554Q

Re:Update on Samsung SSD Reliability by dinvlad on Thursday February 09, 2023 @01:57PM (#34729236)
Hmm, that still seems like it should be ok. Tjmax is usually over 100C (though for NANDs they recommend 70C I think)