News for hackers. Stuff that matters.
Re:Tell HN: IPv6-only still pretty much unusable by tjohns on Wednesday December 07, 2022 @12:39PM (#33897401)
What? No. You connect a device, and SLAAC (and optionally DHCPv6, on enterprise networks) configures everything. It just works.

SLAAC is more than capable of sending DNS settings to devices. There's no manual configuration involved.

Re:Tell HN: IPv6-only still pretty much unusable by tjoff on Wednesday December 07, 2022 @01:04PM (#33897762)
My post said to use DHCPv6 and RDNSS. Follow up claimed to use SLAAC instead.

SLAAC does not do DNS. Clear as day?

Re:Tell HN: IPv6-only still pretty much unusable by tjohns on Wednesday December 07, 2022 @01:24PM (#33898031)
SLAAC does DNS, with the RDNSS extension enabled. (RDNSS is a feature that was added to SLAAC.)

Some older devices [1] do not support RDNSS. I haven't run into them, but if you're at all worried about it, you can run DHCPv6 in parallel just to hand out DNS settings.

Personally, I just use SLAAC (with RDNSS) and it just works.

[1]: https://en.wikipedia.org/wiki/Comparison_of_IPv6_support_in_...

Re:Tell HN: IPv6-only still pretty much unusable by ipython on Wednesday December 07, 2022 @03:25PM (#33899761)
I run dual stack at home and every device I have connected to my home network runs ipv6 with no manual configuration whatsoever. It’s easier than ipv4 when you consider providing inbound access to resources (no nat configuration)