News for hackers. Stuff that matters.
Re:Matthias Wandel woodworks his way to 1.72M subscribers by logical_proof on Tuesday November 22, 2022 @07:35PM (#33713546)
Don’t act like re-toothing a crosscut saw is some easy process and everyone has all the tools available :) at a minimum you need the correct needle files, a saw set, a bastard file, some kind of vice preferably a saw vice, and the skill on what pitch and yaw to file at. Hand saw sharpening like most woodworking is a lovely ‘rabbet’ hole.

Edit: this was meant as a bit of tip of the hat to anyone who can sharpen a crosscut panel saw, not snark.

Re:Matthias Wandel woodworks his way to 1.72M subscribers by tharkun__ on Tuesday November 22, 2022 @07:42PM (#33713606)
I never said it's easy if you have nothing yet. But it's satisfying ;)

And yes, I started by building Paul's workbench actually. I built the version that uses regular old 2x4s and 2x6x glued together. He also has a version using plywood. I built it using only hand tools I bought off Ebay and the "work bench" I used to build that was just some old Ikea table I had. You might use a couple of cheap saw horses and a sheet of plywood.

And yes, I bought files, both to get rid of the existing, bad, teeth and cut in the new teeth. Also a tooth setting tool for the left/right 'bending'. I only did that once I had his work bench finished and a vise mounted to it. No "saw vice" (whatever that is) needed. FWIW, I've only had to sharpen my rip cut saws so far though. Cross cut will be harder, yes. Looking forward to it!

Also I see you meant your reply in a good way, i.e. yes, I'm way down the rabbet hole. I do have a manual router from Lee Valley ;)