Actually, it would be possible. Under this speed, you would have an expressive delay (when compared to switching times) between the control and the output and the device would have parts of it in different states of a switch.
Not a very practical idea, but it's not impossible.
Re:Memristor cell scaled down to 10nm
by Tuna-Fish on Thursday December 15, 2011 @05:55AM
(#3355684)
Actually, no. Memristors work by moving around oxygen atoms, and the read and write signals share wires. The write signal has to reach over the entire length of the cell, for some time, for a write to be successful. You can't even begin reading until the write has finished, and the write signal, which has orders of magnitude higher current than read, has been cleared from the wire.
Cool. I hadn't realized the read and write lines were the same. In that case, you really can't use the device as a delay-based sequential memory.
What the text means that it can switch once per 1ns, and it has proven to have endurance of more than billion switches for the lifetime of the cell. So yes, it can do all those billion in a single second. And yes, it thus probably isn't good enough to replace DRAM yet.