According to this setup their under load power consumption of the entire system was just shy of 700Ws https://pcper.com/2014/10/nvidia-gtx-980-3-way-and-4-way-sli...
Back then components didn't tend to be as power bursty so I think it matters whether you compare peak power consumption or average power consumption under "typical" load.
A wall load from a gaming PC with a 4090 and 13900k is definitely going to burst passed 700Ws, but average while playing a game is probably lower than that.
That said, that review mentioned several very power hungry SLI setups.
Keep in mind, while the US uses 120V at the outlet, virtually all residential service is 240V (typically two phases of 120V), so in theory your home has 240V@150A=36 kilowatts of peak capacity. With some high gauge extension cords to distribute the load to different circuits in your house, you'll likely run out of space or friends before you run out of power.
It's still single phase, one AC sine wave. The transformer supplies power using three current carrying conductors, two hots, and a neutral. The voltage, or potential difference, between the two hots is 240V. The neutral is a center tap on the transformer, and the voltage between each of the hots and the neutral is 120V. This allows circuits to use either or both 120/240V.
You are correct, however, in your math for total capacity.
Back in the early 00's, I've had 20A breakers trip with ~8 high-end PCs on the same circuit. Today, I think we would struggle to handle half the number of PCs. My entire panel is only good for 150A of service, so I am wondering if I could even fill up a battlefield match before my main trips.