News for hackers. Stuff that matters.
Re:Parallel Curves of Cubic Béziers by aaronblohowiak on Friday September 09, 2022 @08:02PM (#32786335)
if you have a curve you need to make a parallel to, like for making a two part form for bent lamination, a common trick is to use a washer. you run the washer along the reference curve and your pencil in the hole in the washer. this gives you the parallel curve offset by the width of the solid part of the washer.
Re:Parallel Curves of Cubic Béziers by pciexpgpu on Friday September 09, 2022 @10:53PM (#32787274)
This sounds even better. I was imagining a similar idea where for every point in the Bezier you have a normal that can extend both directions by a specified amount. The smoothness still requires some interpolation which shouldn’t be too further from normal Bezier interpolation.
Re:Parallel Curves of Cubic Béziers by surfskatr on Saturday September 10, 2022 @02:11AM (#32788272)
Great way to put this thanks. Was also confused between parallel and translated curve, as when sketching a design I’d usually do the former.
Re:Parallel Curves of Cubic Béziers by db48x on Saturday September 10, 2022 @07:50AM (#32789800)
That’s exactly what dilating a curve with a circle means :D