News for hackers. Stuff that matters.
Re:A Phoenix record store owner set the audiophile world on ... by kazinator on Friday August 05, 2022 @04:27PM (#32361580)
If the goal is audio capture and reproduction, the filter used when sampling at 96 kHz still starts rolling off at around 20 kHz. The wrap-around aliasing artifacts do not begin until around half of 96 kHz, or around 48 kHz. So the filter only has to be steep enough to hit a large attenuation at 48 kHz: full signal to virtually nothing over the space of 28 kHz.

If you're sampling at 48 kHz, the signal has to be severely attenuated already; it has to go from 20 kHz to deep cutoff in just the space of a few kHz.

At 96 kHz can achieve the effect as if you were sampling at 48 kHz, with a steep filter. You sample at 96 kHz with a milder filter, and then purely in the digital realm, you down-sample to 48 kHz. There is an overall filter consisting of the original analog one plus the digital processing.

That is cheaper and more reliable than doing it all in analog.

An analog filter with a steep cut off will be challenging in mass production because of the strict component tolerances.

Sure, you could use a steep filter with 96 kHz also. Say, a steep filter that starts cutting off at 30 kHz. It would still be a less demanding filtering application because of the margin that you have in the frequency domain. The multiple poles of the filter don't have to be lined up as well. E.g. if the first pole starts rolling off at around 30 kHz, and then next ones at 31, and the third one at 28, ... it doesn't matter because you're still hitting the absolute target of there being next to nothing at 48 kHz, and nearly the full signal at 20 kHz.

Re:A Phoenix record store owner set the audiophile world on ... by PaulDavisThe1st on Friday August 05, 2022 @05:19PM (#32362097)
You're right, and I'm wrong.
Re:A Phoenix record store owner set the audiophile world on ... by Sporktacular on Friday August 05, 2022 @06:47PM (#32362841)
Sure, but going to disagree about the numbers there. I have a DAW interface which is exceedingly linear (+/- <0.15 dB) up to 35 kHz. Don't need to start filtering so low to hit those results.