> If you have an application using a pad, and it's flat enough to replace with (good) paste, you will always see a performance improvement.
if the tolerances are tight enough, if the heatsink doesn't even touch the VRM thermal paste won't do nothing.
Re:The GPU shortage is over
by exmadscientist on Saturday July 02, 2022 @05:40PM
(#31962720)
That's a fair point -- I was assuming contact and already moving on to surface roughness!
I do not ever re-use pads. I have a used pad on my desk at work that shows an indent of the chip that was pressed into its other side... and you can read the part number and lot code laser marked into the chip. If the pad conforms to that but then can't relax back... it's never going to make good contact again. Full stop. (Granted, this was an extremely expensive thick gap-filler pad [TG-A9000, I think] for a particular application, and performance will vary.)