They don't make a big deal about it when they improve the capabilities: in the past they've also improved minimum via ring diameter from 0.45mm to 0.4mm, which doesn't sound like much but it allows you to fit the vias in between 0.8mm pads on inner layers.
Patiently waiting for the day microvias become too cheap to meter.
But if you want signals in those inner balls... still pretty tight. And the 15x15 ECP5 is the absolute max this would work for; after that you hit both needing inner layers to route on, and additional ground planes for the outer layers' return current.
Or do you mean if you want to connect to both the outer as well as the inner layer of balls? Then you'd be right I think, but that was not what I meant; I only calculated the spacing to connect to the outer layer and nothing more.
Simple chip scale bgas can be broken out one layer, but the geometry requires capabilities that only multi layer process provides.
The real takeaway is JLCPCB just got a whole lot more competitive with there 6 layer service. 0.2/0.4 vias, 0.1 trace/space is the holy grail. Anything smaller geometry than that you need board house support, and a finely tuned assembly process.
0.127mm = 5 mils. Note that is it impossible to achieve +/- 0.001 mm tolerance in PCB manufacture, so including 3 digits' precision is - not helpful.
0.254 mm = 10 mils
.35mm pitch = 13.78 mils (why not 14? Because on packages, with lots of pads, you'll get errors if you don't account for small fractions)
0.09mm = 3.5 mils
1 mm = 39.37 mils
PCB manufacture traditionally has been done in mils, with good reason: you can use no decimal-point representations of most of the useful quantities in PCB layout.
And, don't you love 100 mil, 50 mil, 2 mm, and 1 mm connectors ? Not to mention 156 mil and https://www.samtec.com/connectors/high-speed-board-to-board/... which has 0.8 mm pitch. I soooo love connectors, if I were a Connector Manufacturer.
The fence post error of PCBs, you need 4x the minimum spacing / trace width to breakout without vias. 1x trace, two spaces, and half a trace on both sides to match your BGA pitch. Best you can do on JLC is a 2 row 0.5mm breakout without resorting to tricks. You really need 0.1mm capability for these tiny pitches.
Edit: Just double checked JLC, their 4 layer does offer full 0.09mm capability, which is new! It use to only be the outer layers that could be 0.09mm, and 0.127 on inner layers. You can actually do a proper 0.8mm BGA breakout now, and 1mm pitch is child’s play now, you can fit two traces between vias.