Re:Using a tiny HC32L110 ARM chip
by PennRobotics on Monday March 21, 2022 @07:33AM
(#30752809)
The specs on the laser for an LPKF say plated vias down to 200 um diameter.
[ Parent
| on HN ]
Seems like that might be just small enough to make this work?
Re:Using a tiny HC32L110 ARM chip
by PennRobotics on Tuesday March 22, 2022 @06:49AM
(#30764606)
I imagine a microvia cut by laser would work quite nicely on three of those pins.
The fourth pin, Vcap, would be frustrating, because using two vias to place a capacitor on the opposite side of the IC is labor-intensive, and using two vias to place a capacitor beside the IC is a bit of an unnecessarily long signal path for a filtering component. I'd rather gouge a hole and solder a capacitor directly onto the IC between Vcc and Vcap, but "gouge a blind hole in the dielectric and solder an 01005 capacitor to the IC" is not a commercially viable answer either.
Maybe pray your design doesn't need Vcap or that this can be tied to GND?