My interesting battle story around this is that I first implemented the MDIO as bit banging in the kernel. This used quite a bit of CPU, which I wanted to use for other things. I switched it over to the PRU and CPU usage dropped to 1%. Great! But the data rate was much slower, with huge latency spikes. It turned out that the CPU usage was so low that the CPU governor thought the system was idle, so was throttling the CPU to just a few hundred MHz. I had to change the governor to keep the CPU clock to 100%, then everything was about 10x faster.
If your PHY’s data sheet says clause 45 register access only and you don’t have GPIO access as the bus master, run away.
Unfortunately I was tasked with emulating a clause 45 PHY on a clause 22 bus. Without creative use of the microcontroller peripherals, it is next to impossible to achieve implemented a 2.5Mhz slave.
I had to use an edge interrupt to jump in to a while loop state machine, whose state was determined by a timer counter driven by the MDIO bus, with all GPIO acessd via hard coded bit banded GPIO.
Fun times, but this is definitely an FPGA job.
> OUT EXEC allows instructions to be included inline in the FIFO datastream. The OUT itself executes on one cycle, and the instruction from the OSR is executed on the next cycle. There are no restrictions on the types of instructions which can be executed by this mechanism. Delay cycles on the initial OUT are ignored, but the executee may insert delay cycles as normal.