Re:5.5 mm in 1.25 nanoseconds
by formerly_proven on Saturday January 15, 2022 @07:33AM
(#29945878)
The common mode problem can be avoided by making the experiment not differential (which coincidentally saves half the wiring) but even if you do that, you still get a large influence on the result due to the coupling between the twin-lead line and ground. It's actually a pretty good demonstration why using baluns for twin-lead is necessary; only the differential mode of the line works well, because it's not actually a two-conductor line, as it's an open line it is also coupled to ground. In my experiment (with ~6 cm wire spacing, which makes relatively little difference as the impedance of the line is proportional to the log of the spacing) I found that suspending it around a meter above ground gave almost identical differential and common mode impedances. That of course rather significantly reduces the amplitude you're going to see in the experiment.
If you look at his scope plot, the common mode voltage is kind of a mess and much larger than the actual differential voltage. That doesn't give me a lot of confidence in the final result. I'd like to see a more controlled version of this experiment with better equipment.
Source: I've done the same thing he did, using two probes to measure a differential voltage, and I can tell you it kind of works, but not well. Especially not at higher frequencies.