There are mitigations steps you can take with an EV: don’t keep it fully charged for long, don’t supercharge too often, store it in a garage and keep it plugged in so it can regulate the pack temps without cycling it. One problem is I don’t know how you can evaluate the health of a pack when buying used.
The best is to connect something on the ODB port of the car and collect all the technical values.
You need to remember that the battery temperature can influence a lot.
The temperature does influence a lot, but it only influences within a range that's allowed by the current health status of the battery.
In my mind, this status is what should be somehow visible / easy to check. As opposed to trying to estimate it given the current temperature and the reported range when X% full or whatever.
My iPhone says its battery is X% healthy. I've seen my battery drain quicker when I was using the phone intensively by 0 °C than when it sat on my desk doing nothing at room temperature. But the health indicator didn't go up while in the office.
A full "coulomb count" of a battery can somewhat reliably estimate the amount that a Li-Ion battery has worn out. Its a pretty simple idea:
1. On one charge-cycle... count every electron that enters the battery.
2. As its discharging... count every electron that leaves the battery.
Typical phones and laptops will perform a coulomb count whenever you go through charge / discharge cycles (and a full coulomb count will only occur if you go from 0% charge to 100% charge... and a full count is the most accurate).
However, this is an external "blackbox" estimate to the life of the battery. You don't really know the battery's condition. There's no chemical test involved where you're sampling the contaminants inside of the Li-ion cells.
Is this "good enough" for when you're purchasing a used car / computer / iphone or when you're thinking of taking that long trip with your already well-worn Tesla?
---------
I'm fairly certain that any accurate chemical test would destroy the cells, at least with our current level of technology.
As such, its not a question of "good enough". Its simply a question of "what is possible". Since nothing better is possible yet, Coulomb Counting is our best methodology.
None of those parts cost $22,000+ to repair though, like a Li-ion battery that's fundamental to the electric car.
We all know how to repair cylinders, pistons, or even engine-lift, transmission repairs or whatever. All those costs are well calculated and well known.
Unless maybe he bought it new and stored it without driving it for eight years, until the warranty had expired, and then ran into problems when he started driving it?
There is either more to this story or one of the worst customer service stories in history.
Coolest detonation sequence is the slomo that starts ~6:22.
No. It was a used car from 2013. The number of miles on the car (and therefore, the charge/discharge cycles) is not reported. I drive about 10,000 miles/year, others closer to 20,000. So the number of miles on that car is probably 80,000 to 150,000 or so.
> There is either more to this story or one of the worst customer service stories in history.
Tesla is well known to have bad customer service.
The chemistry is only good for a number of charges. This is also affected by temperature, I'm sure that in a cold nation like Finland, the batteries wear out faster.
You can hide this by making redundant cells and with some intelligent software to wear-balance the cells. But eventually, the physical chemistry of the lithium ion just wears out. You can't stop physics.