News for hackers. Stuff that matters.
Re:Show HN: I built a CNC-machine from scratch, using 40x 3D... by phkahler on Wednesday November 03, 2021 @03:18PM (#29099082)
Do any of these small CNCs support G02 and G03 for circular arcs?

I was recently looking at G-code output from Solvespace and figure we need to update it to produce those codes rather than tiny linear segments. But will the home-built CNCs even support that?

Re:Show HN: I built a CNC-machine from scratch, using 40x 3D... by vvoid on Wednesday November 03, 2021 @04:46PM (#29100051)
LinuxCNC will (http://linuxcnc.org/docs/2.8/html/gcode/g-code.html#gcode:g2...) - but your CAM may not.

Edit: did not realize I was replying to solvespace, bring on the arcs!

Re:Show HN: I built a CNC-machine from scratch, using 40x 3D... by phkahler on Saturday November 06, 2021 @05:54PM (#29134150)
>> Edit: did not realize I was replying to solvespace, bring on the arcs!

There's a guy working on a g-code template right now. It should substitute the g-code into the template on export so it's machine ready.

I'd like to get into all that, but I'm still working on construction tools and stuff.

Re:Show HN: I built a CNC-machine from scratch, using 40x 3D... by opencl on Wednesday November 03, 2021 @05:13PM (#29100341)
Most of the small hobbyist machines I've seen (including this one) use Grbl, and Grbl does support G02/G03.
Re:Show HN: I built a CNC-machine from scratch, using 40x 3D... by dekhn on Wednesday November 03, 2021 @08:15PM (#29102245)
grbl supports arcs and it represents the most common Gcode firmware on these "home-builts"
Re:Show HN: I built a CNC-machine from scratch, using 40x 3D... by Robotbeat on Wednesday November 03, 2021 @03:19PM (#29099094)
I think Marlin supports it.