News for hackers. Stuff that matters.
Re:Where are the robotic bricklayers? by mauvehaus on Wednesday August 04, 2021 @07:52AM (#28059885)
There are, on the other hand, ways to combine the old and the new harmoniously. I'm building a cabinet on stand, and because there are drawers behind a door, the pulls need to be inset.

Carving the undercut by hand is pretty time consuming (i.e. unprofitable). But I have access to a CNC router. I laid out a template in FreeCad, and cut it out. Using template bushings and an edge fluting bit with the bearing boss ground off, I can cut the pulls with the undercut in a couple minutes each. And they come out more regular than doing them by hand.

I'll admit that I'm not much of a carver, but I don't think I could get the time per pull down anywhere near that while maintaining the same consistency even with a lot of practice.

There are no comments on this comment yet.