Why did bar ends go away from mountain bikes?

Re:Why did bar ends go away from mountain bikes? by lwansbrough on Monday May 24, 2021 @12:35PM (#27266432)

In my experience you actually don’t need additional traction on the front tire during ascents. You want more traction on the back tire, so leaning forward is more likely to cause slipping. Wider bars makes balancing easier and frames designed to keep the back wheel on the ground (by distributing more weight to the back tire) make it easier to climb.

[ Parent | on HN ]

Re:Why did bar ends go away from mountain bikes? by midnightclubbed on Monday May 24, 2021 @04:22PM (#27269253)

Back in the days of 26" hard-tails you definitely needed weight over the front wheel to keep it on the ground - there was a fine balancing act of keeping enough weight over the front to not lose control while keeping that back wheel from spinning out. Modern bike geometry is so so much better! (having tires 2.3+ inches wide helps with traction too!).

[ Parent | on HN ]

Re:Why did bar ends go away from mountain bikes? by dahart on Monday May 24, 2021 @05:27PM (#27269938)

Yup, I needed to use a travel-adjust fork on my 26" full-suspension to get up steep inclines without looping. The 29er with today's geometry makes looping on a steep section so much less likely.

[ Parent | on HN ]

Re:Why did bar ends go away from mountain bikes? by dev_tty01 on Monday May 24, 2021 @07:54PM (#27271103)

Pull on the bars in the direction of the rear tire/ground contact patch. This leads to more rear traction and makes a big difference in sketchy steep climbs.

[ Parent | on HN ]