News for hackers. Stuff that matters.
Re:Getting and restoring a Sun Ultra 1 Workstation by greatartiste on Wednesday May 12, 2021 @04:16AM (#27127979)
Back in the day I used to have to repair the CRT monitors for these. They were incredibly heavy and you could do yourself serious harm just lifting one from a box onto your bench. The reason for the weight was that once you had removed the plastic cover there were several layers (depending on the model) of metal screening around the circuit boards. An unusually good level of EMC screening for that time. I presumed these things were all built to military/govt spec to prevent TEMPEST eavesdropping ? Anyway removing all of that wasn't a quick job.

As for the IT part of the workstations I don't ever remember them going wrong they just ran & ran.

Re:Getting and restoring a Sun Ultra 1 Workstation by flyinghamster on Wednesday May 12, 2021 @04:43AM (#27128135)
Even without TEMPEST considerations, once you got up to about 19" or so, CRT monitors got to be downright heavy. Then there was my folks' old TV set, a 36" flat-screen CRT monster that was difficult even for two to lift. That thick slab of glass on the front must have been half its mass. Moving it required planning.
Re:Getting and restoring a Sun Ultra 1 Workstation by tinus_hn on Wednesday May 12, 2021 @05:41AM (#27128449)
Some of them had the hard disks that got sticky disk syndrome when turned off for a week (Christmas holidays) after years of service.
Re:Getting and restoring a Sun Ultra 1 Workstation by Treblemaker on Wednesday May 12, 2021 @06:29AM (#27128695)
> they just ran & ran.

Until they didn't, usually right in the middle of a tape-out.

Nice to see this site is still around, though!

https://www.ibiblio.org/pub/packages/solaris/sparc/