Re:Elevator Sabbath service mode (SHO)
by gnicholas on Sunday May 02, 2021 @02:36AM
(#27012840)
A motion sensor seems to be doing something somewhat different. When there is no motion, no circuit is completed, and the connected appliance (e.g., a light) is off.
Contrast that with a device that constantly scans for faces and is continuously sending instructions to the elevator controller. In this case, it is always sending an instruction about which floor to go to. If no one is present (and nothing is happening on other floors), the instruction is to stay on the current floor, doors open. If someone approaches and is not recognized, then on the Sabbath the instruction would be to go floor by floor. And if someone approaches and is recognized, the instruction would be to go to that person's floor. In any of the three cases, instructions are being sent via continuously-active circuitry. This is different from the motion sensor, where a circuit is completed only when someone is present and triggers it.
But like I said, I know little of this subject, and I'm sure these ideas have been vigorously debated by experts!
Contrast that with a device that constantly scans for faces and is continuously sending instructions to the elevator controller. In this case, it is always sending an instruction about which floor to go to. If no one is present (and nothing is happening on other floors), the instruction is to stay on the current floor, doors open. If someone approaches and is not recognized, then on the Sabbath the instruction would be to go floor by floor. And if someone approaches and is recognized, the instruction would be to go to that person's floor. In any of the three cases, instructions are being sent via continuously-active circuitry. This is different from the motion sensor, where a circuit is completed only when someone is present and triggers it.
But like I said, I know little of this subject, and I'm sure these ideas have been vigorously debated by experts!