I'm just comparing your Bode's Galaxy (f/3.3, 200mm, 120x21s) with my recent attempt (f/6.3, 600mm, 42x30s), and besides magnification, the result seems fairly similar - if anything, I think the dark sections of your image are less noisy. Your arrangement collected about 7.2 times as much light (ignoring magnification), so that's not surprising. I was using a Nikon D7500, so if the RPI HQ camera is comparing reasonably favourably with that, then yes that's not bad.

This makes me wonder what sort of semi-pro astrophotography might be possible using a disassembled small cinema camera (black magic pocket 6k, for instance, or a similar priced full frame mirrorless or DSLR) with a peltier cooler or refrigerant loop heatsink attached to its back side.

How close could one get in performance to a very costly astrophotography setup, for under $10k? Not counting the cost of the telescope/optics in front of it, just talking about the sensor part.

Yeah it's barely usable, but not great, because ultimately larger sensors will still give you better SNR for astrophotography. A sensor with 10X the area will be able to produce an image with the same final SNR in 1/10 the time.

Also I had lots of faint banding issues with RPi cameras. Nobody was able to solve my problem on forums.

https://www.raspberrypi.org/forums/viewtopic.php?t=287866

I've seen similar banding in some tests when I had set analog gain to 1.0 on a warm night. With analog gain set to 16.0 and Peltier cooler attached to back of camera PCB it was gone.

My guess is that IMX477 does some software de-noise that causes banding. I tested this guess by calculating power spectrum of a dark frame and there was noticeable drop in higher frequencies. Unfortunately, even disabling hot-pixel detection did not help. I did not investigate it further.

> Peltier cooler attached to back of camera PCB

Do you have plans or pics of how to do this? Especially how to do it without getting condensation on the electronics?

Thanks!

Honestly, it is just a frankenstein monster of whatever I had on hand: https://imgur.com/a/QhvmbUa

3mm thermal pad I used between PCB and cooler: https://botland.store/thermoconductive-tapes-pastes/6060-the...

Radiator (I used the smaller one that typically goes on cold side of Peltier): https://botland.store/peltier-elements/10024-heatsink-with-a...

Fan is standard 40mmx40mm, there is some generic copper thermal paste between Peltier and radiator. The plywood mount is DIY made with with hole drills. It is a bit too thick so I used 2x C-CS mount adapters (like the one bundled with the camera) to get more space, otherwise I would not be able to screw in lens adapter.

There was a bit of neoprene foam between radiator and fan to reduce vibrations but it looks like I lost it somewhere.

About condensation: it was always wet or even icy in operation but it never caused any electrical issues, I guess condensed water was not very conductive? Once on a cold night (about 5C) I had water condensation on the sensor itself but it did not cause any lasting damage. I've read that putting a fresh silica gel desiccant packet into lens adapter helps. I had plans to attach temperature probe to lens mount and control cooling power form Pi itself, will get back to it in the future. The camera sensor itself has embedded thermometer but it is not exposed in camera driver.