Re:Chip-starved automakers shudder at Renesas plant's 1-mont...
by ahepp on Monday March 22, 2021 @11:55AM
(#26542574)
I think it would be cool if I could use my laptop to adjust EFI like I can on a carb. (without having to crack the ECU or whatever)
[ Parent
| on HN ]
Re:Chip-starved automakers shudder at Renesas plant's 1-mont...
by jeffbee on Monday March 22, 2021 @12:16PM
(#26542862)
I've never seen an ECU you couldn't tune with a laptop. It's a hell of a lot easier to dial in a modern engine than it was when you had to try to find the best combination of jets, needles, and springs.
Re:Chip-starved automakers shudder at Renesas plant's 1-mont...
by ahepp on Monday March 22, 2021 @12:49PM
(#26543325)
You usually need more than the electronic equivalent of a screwdriver though, right? Maybe I'm mistaken. I was under the impression you would typically need something like a Cobb port.
If you can access them, I certainly imagine the efi profiles are much more tuneable.
Re:Chip-starved automakers shudder at Renesas plant's 1-mont...
by bri3d on Monday March 22, 2021 @01:35PM
(#26543912)
Yes, it's usually a fair amount of work, on most modern ECUs there is some form of signature based protection which will require an exploit chain to bypass, and then the need to write either software patches to enable introspection into the parameters necessary to tune, or to reverse engineer the protections on the factory calibration protocols if they were left in production builds. This is all possible with the electronic equivalent of a screwdriver, a Raspberry Pi, but requires a lot of reverse-engineering effort and understanding.