Re:DIY Through Hole Plating of PCBs (2017)
by a1369209993 on Sunday March 14, 2021 @07:10PM
(#26460456)
> just use a piece of wire instead
Pretty much this. If you can solder though-hole resistors on one side of the board, and you can solder though-hole resistors on the other side of the board, you can line the holes up and solder a trimmed-off resistor lead to both sides. Sure it takes time, but so does soldering through-hole components in the first place.
Pretty much this. If you can solder though-hole resistors on one side of the board, and you can solder though-hole resistors on the other side of the board, you can line the holes up and solder a trimmed-off resistor lead to both sides. Sure it takes time, but so does soldering through-hole components in the first place.