Re:DIY Through Hole Plating of PCBs (2017)
by lmilcin on Sunday March 14, 2021 @04:49PM
(#26459013)
>> My biggest issue with DIY boards is drilling the holes and in particular getting the bit in the center of the pad.
Get a small drilling stand that can let you mount the PCB in a vise.
Now, I would still use pre-drilled prototyping board. Drilling all those holes is just such a hassle. I want to focus on designing circuits and boards, not drilling them.
I drill rarely, when the component must be mounted directly to the prototyping board but does not conform to standard 2.54mm pitch or will not fit the premade holes.
Get a small drilling stand that can let you mount the PCB in a vise.
Now, I would still use pre-drilled prototyping board. Drilling all those holes is just such a hassle. I want to focus on designing circuits and boards, not drilling them.
I drill rarely, when the component must be mounted directly to the prototyping board but does not conform to standard 2.54mm pitch or will not fit the premade holes.