In this case, something obviously went awry and it's both engineering, planning, and a miracle no one died or was crushed from debris from above. Regardless, comments like yours leave me feeling far more confident in this sort of thing.
Yes, though even something going wrong doesn't necessarily mean that we'd need to change any procedures.
Sensible procedures bring risks down to acceptable levels at an acceptable price. That level of risk is generally still more than 0%.
But yeah, a D check is so expensive I've heard there's a habit of dumping the aircraft on less observing flying companies some thousand miles before it comes up...
And in a similar incident in February 2018 on a 777 (referred to upthread), one of those checks was found to have failed: the NTSB determined that the root cause was a cracked engine fan blade that should have been detected on a previous inspection (and that would have resulted in the blade being replaced), but wasn't. If this incident turns out to have a similar root cause, that means there are issues with the preventive inspection and maintenance process.
How is that safe unless you've got a production line doing it? Seems impossible to re-assemble it in the same way as it was done in factory...
https://en.wikipedia.org/wiki/Aircraft_maintenance_checks#D_...
A commercial aircraft does not just accumulate wear and tear for 25 years until something breaks. They can basically fly indefinitely, but in reality after two or three D checks they are usually retired because the cost of the D check is more than the value of the aircraft.