But replicating that with an ATMEL or similar generally requires dancing around with resistor ladders or similar.
For the output side, I guess I you can tri-state the output, but this will by default keep the previous voltage, you will need some resistors to actually emit a voltage outer than "low" or "high". And Z80 cannot even control this on per-pin basis, since it has no integrated GPIOs.
For the input side, I have no idea how would Z80 get more than two states. All the peripherals I know of (like 82C55 GPIO chips) also only provide two input levels as well.
The only way to get 3-state input into a system I can think of are:
- ADC input followed by software thresholding (this will be pretty slow, and works with hundreds of states, not just 3)
- Use external voltage comparators to split a single input wire into multiple input pins. This no long is "single pin" though.
- Some FPGA/CPLDs have multiple banks with changeable input thresholds. This lets you avoid external comparators. You'd still need multiple pins for each input wire.
Note that this link is tri-state, not ternary. The "tri-state" is still binary, the third state is to allow attaching multiple outputs to the same bus. Or in the C pseudocode:
Regular binary:
Ternary: Tri-state (as Z80 and every modern computer does it): (the idea is you might have multiple components driving the same "value", and only one of them should be enabled at a time. Bad things happen if more than one is enabled at a time, or none are)