Beginners should not ever clean flux. Most hobbyists should never need to clean flux. Professionals should have data driving any decision to clean flux.
I never considered flux compatibility between my solder rosin core and the flux paste and never considered measuring salt residues on the board.
I almost exclusively use the same Kester sn64pb37 rosin core solder and MG Chemicals #8342 RA rosin flux paste. Both must be cleaned promptly. Now, I don't bother cleaning if I don't intend to use the board after I test it (like when I do prototyping) but anything else gets a thorough wash. I use various PCB cleaners, typically ethanol (not IPA!) based and then rinse boards in electronic water. I never saw any oxidation on any of the traces unless there was some external contamination.
1) On page three, that exposed end of the lead is a defect if you're NOT going to conformally coat the board. If you don't know what a conformal coating is, it's a defect.
2) On page eleven, flux residue. Sure, for NASA's applications. For most commercial applications, the IPC rule is "excessive flux residue". For prototypes, one-offs, and hobby projects, my rule of thumb is, if you can't measure the difference removing flux makes, leave it there. Incompletely cleaned flux can be more corrosive than undisturbed flux. Also, no-clean flux should be called "never clean" flux. Never clean it with ordinary methods because you will never get it clean.