Re:NASA's Through-Hole Workmanship Req (2002)
by audiometry on Thursday December 17, 2020 @09:45AM
(#25455997)
I've been told that in areas where lots of prototyping isgoing on, there is lots of scope for manual rework. (a pcb design only 95% correct needs modifications to figure out the right design)
[ Parent
| on HN ]
Re:NASA's Through-Hole Workmanship Req (2002)
by phkahler on Thursday December 17, 2020 @10:44AM
(#25456568)
We had a board where somehow the footprint of an 8 pin SOIC got flipped in the layout. One engineer was able to desolder it, flip it, and solder it on using wires so that it floated about 1-2 cm above the board upside down. I was impressed ;-)
Re:NASA's Through-Hole Workmanship Req (2002)
by garaetjjte on Thursday December 17, 2020 @12:34PM
(#25457846)
So-called "dead bug" method.