News for hackers. Stuff that matters.
Re:South Korea's fusion device KSTAR runs for 20 seconds at ... by pfdietz on Wednesday December 02, 2020 @08:20AM (#25276077)
The Molten Salt Reactor designs I have seen have lower volumetric power density than PWRs. The MSRE reactor had a volumetric power density of 2 MW/m^3, a factor of 10 lower than a commercial PWR (counting the volume of the entire primary reactor vessel; the power density in the core of a PWR is a factor of 5 higher than that.) Of course that was an experiment, but look at something like Moltex's design and the power density is still lower than a PWR, last I looked.

> Likewise, while ITER is uber expensive like large PWRs, ARC is 10 times smaller, and a factor of 30 times or more cheaper.

The ARC design is smaller than ITER, but it's still very much lower (a factor of 40) in power density than a fission reactor.

Re:South Korea's fusion device KSTAR runs for 20 seconds at ... by cromwellian on Wednesday December 02, 2020 @05:20PM (#25282494)
The power density isn't the only variable that matters. The difference doesn't matter if the cost to build a Thorium Molten Salt Reactor is much lower, especially in terms of safety and size. MSR's don't need enormous containment vessels, they also reprocess fuel.

Here's some links showing power densities inline with PWRs, or greater:

https://www.nextbigfuture.com/2013/12/molten-salt-reactor-ab...

"Extrapolating from other liquid-to-liquid heat exchangers, roughly 150 MW/m3 is a practical upper limit to the power density of a primary-to-intermediate salt heat exchanger. For comparison, pressurized-water reactor core power density is ~110 MW/m3." https://info.ornl.gov/sites/publications/files/Pub29596.pdf