Re:ESP32-C3 WiFi and BLE RISC-V processor is pin-to-pin comp...
by Rebelgecko on Monday November 23, 2020 @01:22AM
(#25184083)
Just curious, have you been running it long enough to extrapolate that? I have some TTGO boards and they're a mixed bag. On one of the eink ones (which you'd think is the perfect scenario for deep sleep), they used a lipo chip that shuts everything off if the power draw is too low, so if you try to deep sleep the device never wakes back up
[ Parent
| on HN ]
Re:ESP32-C3 WiFi and BLE RISC-V processor is pin-to-pin comp...
by w3p706 on Monday November 23, 2020 @02:04AM
(#25184238)
No, I did not, but I made tests with a configuration that was using more power.
I measured total runtime per wakup, and number of wakeups until the battery was depleted. I used this data to estimate the runtime if I take a measurment only every 5 minutes. This does not fully take in account the deepsleep current & battery self discharge. But wake up from deepsleep is definitly working.
From 3.7V to 2.7V I coud activate 37'000 times with a total runtime of about 8h.
Schematic is found here: https://github.com/LilyGO/LILYGO-T-Energy/blob/master/t18_v3...
You also have the battery voltage on IO35 with a 2x100kOhm Voltage divider.
The setup is not perfect, but good enough so far, and practical.
If I start over, i would look into * taking a processor with lower speed und power. * taking CR 123 or a battery optimized for very low self discharge current. * Use a wireless protocol with very low overhead. I use ESP-Now now, WLAN would cut battery life in half.