News for hackers. Stuff that matters.
Re:Transmit Radio Signals via Ethernet by 4gotunameagain on Sunday November 08, 2020 @11:26AM (#25026769)
This does not magically increase the power radiated by an ethernet cable or somehow change the base frequency of the interference. Furthermore, the power levels are very low. If you check the link at the bottom, he is using a directional (Moxon) antenna to receive this faint signal. If this could somehow pose an issue with anything, it would have been caught in EMI testing of all network equipment sold
Re:Transmit Radio Signals via Ethernet by avian on Sunday November 08, 2020 @12:21PM (#25027187)
As others have pointed out, EMC testing often only considers typical use and this is not one.

Another thing is that regulations don't only consider radiated power. Constant-level spurious transmissions are sometimes tolerated to a higher degree compared to modulated ones (e.g. in some bands maximum allowed interference is determined by quasy-peak level, not power). This is exactly because modulated interference (which is what this produces) is more harmful to communications systems.

Re:Transmit Radio Signals via Ethernet by vvanders on Sunday November 08, 2020 @12:11PM (#25027129)
Part 15 is pretty clear that any harmful interference should be minimized[1]. Even though it's low power that doesn't mean that it still can't be picked up. Just because equipment is sold at retail doesn't give you a free pass on it.

Take powerline ethernet where the power levels are "low" but still can cause significant issues[2].

[1] http://www.arrl.org/part-15-radio-frequency-devices#Myths

[2] http://www.elmac.co.uk/RF_Emissions_of_Powerline_Ethernet_ad...

Re:Transmit Radio Signals via Ethernet by jcims on Sunday November 08, 2020 @11:56AM (#25027014)
I think the issue is introducing a signal (particularly morse code) on a noise source that is typically steady state. I can pick it up pretty easily with just a bare UHF connector, no antenna.

Low risk overall but it's a good reminder.

Re:Transmit Radio Signals via Ethernet by 60Vhipx7b4JL on Sunday November 08, 2020 @03:28PM (#25028703)
It does not increase power. But it couples data instead of static noise into the communication which might be more annoying on the other end.
Re:Transmit Radio Signals via Ethernet by JosephRedfern on Sunday November 08, 2020 @11:29AM (#25026796)
Does EMI testing consider "atypical" uses like this one? I'd assumed that they only tested normal use cases. I'd consider (wrongly, perhaps?) changing speed of a NIC several times per second to be an atypical use.
Re:Transmit Radio Signals via Ethernet by londons_explore on Sunday November 08, 2020 @11:29AM (#25026791)
EMI testing only tests a product during typical use.

It's very possible to transmit illegal power levels with software mods, or even carefully crafted data packets in some cases.

Re:Transmit Radio Signals via Ethernet by derefr on Sunday November 08, 2020 @11:50AM (#25026953)
> or even carefully crafted data packets

Unless you’ve made custom PHY hardware for those data packets to be pushed onto the line through, your data packets are going to be line-coded to ensure that the signal is self-clocking. Which basically precludes boosted harmonics.