Re:Washington crews destroy first U.S. “murder hornet” nest
by derefr on Sunday October 25, 2020 @12:27PM
(#24887454)
Perhaps they could put a tiny antifuse in circuit with the battery inside the IC package. Supply external "programming" current to the IC, and it would melt the antifuse and get the battery going.
[ Parent
| on HN ]
Re:Washington crews destroy first U.S. “murder hornet” nest
by petertodd on Sunday October 25, 2020 @12:34PM
(#24887509)
The whole device is encapsulated for waterproofing so supplying any current at all to it is tricky.
It says it's light activated. So likely they've put a tiny light sensor in it that the microcontroller polls occasionally during the lowest power mode. That might be a tiny solar panel too. But using that to electrically drive an electronic power switch is tricky if you don't have the budget for a custom ASIC; if you don't have that budget, you'll add a decent amount of weight in a device that tiny.
Honestly, I'm not at all surprised that they've chosen to accept a short shelf life instead. It's pretty remarkable that they can squeeze that much functionality into a 11mm long by 3.5mm diameter cylinder.
Re:Washington crews destroy first U.S. “murder hornet” nest
by Johnny555 on Sunday October 25, 2020 @12:30PM
(#24887482)
I would think that the engineers developing then already did the cost benefit analysis and decided that shipping them activated (and tested) is the best option for their users
Re:Washington crews destroy first U.S. “murder hornet” nest
by MertsA on Sunday October 25, 2020 @06:16PM
(#24890481)
Or just bring one of the battery leads out of the encapsulation and cut it. Just a tiny bit of solder and you hook it back up. With the rest of the device waterproofed just one tiny exposed contact should still remain waterproof with thin gauge solid conductor wire. There's no voltage differential so it shouldn't rust moreso than just a regular blob of solder exposed to the elements.