As far as I know, a USB-C charger should never have a hot V+/V- and that is what my beard trimmer requires. EDIT: alias_neo corrected me, and pointed out that it's D+/D- I'm thinking about.

On the other hand, this is expected behavior for a USB-A charger, and thus for a USB-A-to-C cable.

Your beard trimmer is likely missing the 5.1k resistors to GND on the CC pins, which enables the USB-C charger to output 5V. I had several devices (mostly flashlights with integrated battery chargers) that would only charge using A-C cables. After adding the resistors, C-C cables also work.

Probably, yes. I could do some soldering on the beard trimmer, but the electronics in the earbuds are positively microscopic.

Perhaps you mean D+/D-? You won't get very far if V+/V- aren't supplying any current.

Actually, V+ (the correct name is Vbus) not supplying any current is the correct initial state for a USB-C socket. It instead provides a small current on each of the two CC pins (usually through a pull-up resistor on each pin), and only after it detects that the other side is drawing that current (usually through a 5.1kΩ resistor to GND on each pin) will it supply power on Vbus.

Yeah I think you're right! Updated my comment.

The USB-C Madness never seems to stop.

Wait... How does it charge if it does not supply voltage?

Another poster on this same level provided the info! I made an error.