News for hackers. Stuff that matters.
Re:Lasers to replace spark plugs in gasoline engines by ajays on Friday April 22, 2011 @11:10AM (#2474288)
It's all fine and dandy till a speck of soot blocks the optics, and the engine dies.

A better solution (IMHO) would be to have multiple spark plugs.

Re:Lasers to replace spark plugs in gasoline engines by lutorm on Friday April 22, 2011 @01:04PM (#2474654)
Yeah that seems like an obvious problem to anyone who's looked inside a combustion chamber. I wish they'd mentioned something about how they think this is not a problem.
Re:Lasers to replace spark plugs in gasoline engines by jimmyk on Friday April 22, 2011 @02:12PM (#2474887)
It seems to me like that kind of concentrated power would be capable of vaporizing any small particles (or even turning them into plasma briefly) in the way.
Re:Lasers to replace spark plugs in gasoline engines by lutorm on Friday April 22, 2011 @02:36PM (#2474963)
Maybe, but they say that it's focused in the center of the chamber because that's where you want ignition to start. In that case, you might not have that high flux at the entry aperture (you might not want this for other material reasons, too). In any case, I don't think you want to start combustion at the edge because that's the least efficient place to do it.
Re:Lasers to replace spark plugs in gasoline engines by mhb on Friday April 22, 2011 @03:37PM (#2475174)
Maybe the beam is wide enough before it is focused so that the soot wouldn't block enough of it to be a problem before the soot is blown out of the chamber.
Re:Lasers to replace spark plugs in gasoline engines by lutorm on Saturday April 23, 2011 @02:18PM (#2477253)
... before the soot is blown out of the chamber.

You've never looked inside an old engine, have you?

Re:Lasers to replace spark plugs in gasoline engines by mhb on Saturday April 23, 2011 @09:54PM (#2478094)
No. But I only intended to address the point that if the beam is focused in the center then it would take more than a speck of soot to block the wider, lower flux, defocused beam where it enters the cylinder.
Re:Lasers to replace spark plugs in gasoline engines by ars on Friday April 22, 2011 @04:29PM (#2475330)
Carbon has a very high melting point, never mind boiling point. If you would heat it up that much you would melt the optical port.

However, you can simply heat the carbon (all that energy has to go somewhere). Once it's hot enough it can burn in the chamber - and it would probably be hot enough to ignite the fuel as well.

That said, I don't think soot is that common anyway. Normally you run lean which prevents soot. It does need to be able to self clean, but occasional poor efficiency from soot should not be common enough to hurt.

Re:Lasers to replace spark plugs in gasoline engines by gallerytungsten on Friday April 22, 2011 @01:24PM (#2474721)
I was wondering about that too. Perhaps the laser is powerful enough to be "self-cleaning" and blast through the soot.
Re:Lasers to replace spark plugs in gasoline engines by fleitz on Friday April 22, 2011 @03:26PM (#2475143)
An even better solution for efficiency is no spark plugs. http://en.wikipedia.org/wiki/Diesel_engine
Re:Lasers to replace spark plugs in gasoline engines by eco on Friday April 22, 2011 @12:18PM (#2474511)
You should file a patent. I'm sure the automotive industry has not thought of using multiple spark plugs.
Re:Lasers to replace spark plugs in gasoline engines by piranha on Friday April 22, 2011 @01:53PM (#2474818)
Re:Lasers to replace spark plugs in gasoline engines by nickzoic on Saturday April 23, 2011 @03:43AM (#2476455)
Relatively common on motorcycles too (well, not exactly unheard of: my '86 Honda XLV750 has it, as do various recent Ducatis and BMWs.)
Re:Lasers to replace spark plugs in gasoline engines by mkr-hn on Friday April 22, 2011 @01:48PM (#2474796)
Depends on whether or not the soot is transparent on the part of the spectrum the laser operates at.
Re:Lasers to replace spark plugs in gasoline engines by ars on Friday April 22, 2011 @04:23PM (#2475310)
Soot is one of the blackest materials known. It absorbs light in a very wide range.
Re:Lasers to replace spark plugs in gasoline engines by T_S_ on Friday April 22, 2011 @04:52PM (#2475400)
I had an eye operation using a YAG laser. Whatever is not transparent gets heated up and destroyed fast. The blacker the better.
Re:Lasers to replace spark plugs in gasoline engines by johngalt on Friday April 22, 2011 @04:45PM (#2475385)
Been done. Imagine my surprise when I went to tune up my 4-cyl nissan pickup and had to replace 8 plugs.

http://en.wikipedia.org/wiki/Nissan_Z_engine#Z24

On the plus side, the truck still runs clean (300,000 miles later) and gets great mileage.

Re:Lasers to replace spark plugs in gasoline engines by dtegart on Friday April 22, 2011 @06:07PM (#2475577)
To be fair, if your engine is running rich, soot will prevent spark plugs from being able to spark.