Re:CNC Fabric Cutting
by throwaway9d0291 on Tuesday September 22, 2020 @03:28AM
(#24551885)
As a hobbyist, once I have a pattern, cutting out the fabric is by far the most tedious aspect of making a garment. It's just lots of precise handwork. Typically, when I'm making something, it's ~80% cutting, 20% sewing.
By removing that cutting, I'd cut 3h of work down to ~40 minutes.
The variability of clothing isn't great. You can buy 4 pairs of the same pants and they'll all fit differently. When you're ordering online this is even worse as you can't try before you buy.
Having consistent fabric pieces would go a long way to reducing that variability.
For industry it already exists, for hobbyists it's a neat challenge that can remove a remove a boring part and for small scale companies it lets more people be on sewing machines instead of pattern cutting.
Re:CNC Fabric Cutting
by UncleEntity on Monday September 21, 2020 @07:09PM
(#24549369)
> ...enable something that couldn't be done before.
They want to take critical measurements and automagically generate the pattern for the suit.
Kind of like the custom bra manufacturer that was making the rounds a while back I suppose.
The hypothetical use case "Made to measure suits for women" is one that a human with scissors does just fine. I suspect a single person with scissors can do this in less than an hour. The tailoring and sewing is FAR more time consuming.
The point of CNC is either to 1) enable repeatable volume or 2) enable something that couldn't be done before. This falls into neither category.