News for hackers. Stuff that matters.
Re:Designing an Overkill workbench for home office by frosted-flakes on Tuesday September 15, 2020 @08:43AM (#24480548)
Actually, 2x2s are often or usually 1⅜" x 1⅜", which is rather annoying at times. I'm not sure if that has always been the case, but these days they're mostly only available in finger-joint spruce/fir/pine (presumably from offcuts of larger sizes), which might have something to do with it.

(Unlike solid 2x2s, which tend to twist and warp so much as to be completely useless, finger-joint 2x2s are super stable, and always come dead straight.)

Re:Designing an Overkill workbench for home office by TeMPOraL on Tuesday September 15, 2020 @09:43AM (#24481094)
Is there a sane explanation for why 2 = 1.375?
Re:Designing an Overkill workbench for home office by formerly_proven on Tuesday September 15, 2020 @10:20AM (#24481451)
Lumber mills used to separate sawing and milling, so the roughsawn 2"x4" might have been about that (+-5 mm or so), but if you mill that square and (relatively) flat you're loosing a bunch of material. The milled lumber probably still got called 2"x4" since it was made from that. And then things shifted to milled lumber only, and the dimension change stuck.
Re:Designing an Overkill workbench for home office by bluGill on Tuesday September 15, 2020 @10:39AM (#24481684)
Mills cut 2x4 to whatever size close to that then machined it to dimension. Some did a final dimension of 2x4 exactly (within tolerance), others did other sizes. Once you started building something you had to buy everything from the same mill. In some areas this wasn't possible as the yard you bought from changed suppliers.

Eventually they decided enough and standardized on the current size. The standard is more important than the actual size.

Re:Designing an Overkill workbench for home office by frosted-flakes on Tuesday September 15, 2020 @10:11AM (#24481352)
Just a guess, but it's probably because the finger-joint boards are made from short offcuts from the manufacture of larger boards like 2x4s joined together with long zigzag joints. Saw kerfs and finishing sanding probably account for the ⅛" difference in size.

It's usually not a problem, except when it's used beside a 2x4 on the flat, in which case the 2x4 needs to be thinned down on the table saw.