News for hackers. Stuff that matters.
Re:Non-Posix File Systems by gumby on Tuesday September 08, 2020 @10:24PM (#24416194)
Having used both Multics and the Alto, I can add a few points:

Multics as implemented used a slightly different syntax, such as > for path separation.

Segments were not file descriptors but were intended to be what might today be called blocks. The original idea was that the entire memory would essentially be a single address space, with segments being blocks of memory that might be in core, on disk, or on tape (called very slow storage if I remember correctly but it’s been decades). Security was at the segment level, so you could for example have (in posix parlance) an suid shared library that an ordinary program could, with appropriate authentication and permissions, call into in a controlled manner. Multics’ permission structure was more fine grained than the binary of suid. You can see how the backup system kind of falls out of this automatically. I trust some multician will step up and correct any memory-corruption-based thinkos in the above.

Of course reality didn’t quite match the dream and Multics was cancelled before some of that research could be completed. But if you look at the x86 segment registers they could implement something like that. I think this was also in the intel iapx-430 but fortunately even the name of that ancient dead processor is hazy in my mind.

As for the alto filesystem and its descendants: the labels don’t have to be next to the blocks they describe. After all Unix filesystems have multiple copies of their basic breadcrumbs at least. There’s certainly plenty of room for these in modern storage systems; every modern drive, whether spinning or ssd, does a small amount of this in block remapping and wear leveling.

There are no comments on this comment yet.