News for hackers. Stuff that matters.
Re:Soldering is easy - 7 page comic book about how to solder by chaffneue on Tuesday April 12, 2011 @10:49PM (#2440506)
It's a fun guide, but a couple of things irk me. Bending the leads out is a serious no-no - makes it very hard to desolder the component. if there are a lot of components, it' better to solder them in by height, so you can allow tricky parts like diodes, resistors and inductors to rest face down on the table/workstation pad. I think that the things sticking out of ics and semiconductors are usually "pins" not leads. Banging a board on the table can chip the board or get you burned by molten metal... it's better for the entire job to clean the pads of solder with a vacuum tool or desolder braid. Holding your hand over the excess while side cutting is going to hurt and having slivers of tin, copper, nickel and lead in your palm ain't worth it. They should have also had a little aside about wattage as starting with a 45 watt pencil iron is going to suck.

There are no comments on this comment yet.