Internal combustion engines and electric motors are also not rated in the same way. Electric motor HP is "rated" horsepower (what it can produce continuously without overheating; generally it's capable of more for short periods) while internal combustion horsepower tends to be "maximum" horsepower and there are a lot of different ways to come up with a number, some purely based on calculations and some on actual measurement. So unfortunately HP is not an apples-to-apples number between electric and combustion engines.
Not to mention cheaper cars!!!!!
It is not likely that a hybrid car with no direct propulsion from the combustion engine will be 1000 pounds lighter than a comparable conventional car, even if its combustion engine weighs next to nothing. Batteries are heavy, and this type of hybrid needs more of them than the more common type that uses electric to augment the power of a combustion engine.
I'm not saying this won't be an improvement. I'm just saying some of the claims seem a little extravagant.
P.S. For clarity's sake, modern hybrids are enormous compromises due to the weight of the battery and electric motor. For a hybrid you want the highest efficiency possible and thus the lowest total vehicle weight you can manage without compromise safety. The necessity of heavy batteries fights in the opposite direction, so in order to produce a fuel efficient vehicle car makers use more expensive, lighter weight materials in the construction of the vehicle. This increases the complexity of manufacturing (more different materials are being used) and raises the price of the vehicle. If you could drop in a drive-train which kept the weight the same that would change the industry dramatically.
40hp is about what you use on the freeway, or at least it used to be before the average car came to weight 2 tons. You don't need a whole lot more than that. Hell, the MG Midget was offered with a 30HP engine once, IIRC.
I'm quite sure in a decade or two we're going to have people saying things like, "It's true you CAN make a car with only 200hp, but it's generally accepted you need at least 800hp for any car"...
I think the average US car weighed a lot more in the 1960s than in the 1970s, 1980s, or 1990s. Maybe widespread SUV use is pushing that average back up.
Did the http://en.wikipedia.org/wiki/Deux_Chevaux really have only two horsepower?
The fact that a car was once successfully sold in Europe with such a low power to weight ratio doesn't mean it would succeed in today's market. Consumer expectations have changed. They could change again, but there would have to be a good reason.
[0] Lighter cars could be made from more exotic materials, but those would drive the price out of reach of the average buyer.
I can't wait, thanks for the cheery prediction!
Also, it's important to note the reason for the big discrepancy between the "inflated" horsepower ratings modern cars have vs. the lower HP in older classic cars: power is RPM * torque, and gas engines are rated in peak horsepower. To reach the advertised peak horsepower of modern engines, you have to be fairly high RPM (5K to 6K) whereas an older, lower horsepower rated engine might start to drop off its power curve after 4K. But at lower RPM the torques may be similar, or even higher for some older engines (the VW engine in particular with its Boxer configuration was optimized to have good torque for its size). What this means is that unless you are driving full throttle all the time at high RPM, you're not necessarily pushing all 100+ horsepower or whatever that your modern engine is capable of in theory, and so conversely an engine with smaller max horsepower is not as much worse as you'd think it would be.
Not only it's possible, but many successful european cars hadn't more : Citröen 2CV, Renault 4CV, Fiat 500 and 600, and most other economy cars of the 50s and 60s hadn't even that power, and sold by the millions.
I couldn't tell you if the thing is real or not.
But, if such an engine, with two-three times(!!!) the efficiency of a standard gasoline engine with a lower power to weight ratio, were to be producible at 25kW, all the (hypothetical underpowering) problems could be solved by ...
... using ...
TWO engines!! (or three engines)
... jeesh ...
It's for hybrids. Each engine would just charge a battery.
Oh - yeah: I drove a hell of a lot on the German Autobahn with it as well. Fast? Hell no. But I still have that speeding ticket (went just a tiny bit faster than 100km/h) somewhere as a nice souvenir.
0: https://secure.wikimedia.org/wikipedia/en/wiki/Citro%C3%ABn_...
But the design obviously isn't limited to this? A bigger engine could give more power yet still consume less than a regular piston engine. Or 1-2 of these running in parallel, depending on the load.
It should be noted than 25kW is 33HP. Though it's possible to make a useful car with that little power, 33HP is generally considered an appropriate power level for a beginner's motorcycle, not a car. Even if it's much lighter than a piston engine and has such a wide powerband that it doesn't need a gearbox, it's likely they'd need a lot more power for consumer acceptance even in small cars.
Edit: I googled this and found that the intent is to use this engine to run generators to charge batteries in hybrid cars, not for direct propulsion. In that case, the cars probably won't be much, if any lighter than standard cars since all the weight savings will be replaced with batteries. Power output could, of course be lower than a standard car engine and still provide good performance since the electric motors could have peak outputs far exceeding the sustained output of the generator.