I've been working on a Pi Zero W based carputer (really, it's headless and just interfaces with my phone over Bluetooth / the existing radio head unit and steering wheel menu and controls).
Boot time is probably around ~8 second mark currently (fully booted with buildroot / systemd, it's powered from 12V switched by the key) and it already feels fast enough. I normally start my car, put on my seat belt and look around. By the time I've finished doing that it has connected to my phone.
Of course, it would be possible to do even smarter things. Hook up a low power micro that can interface with the CAN bus and a MOSFET, and you can instead power it from the battery and turn it on when the car is unlocked and off after a timeout based on the engine going off.
if Tesla could write their UI stack with the LGPL version of Qt, likely you can do so too (https://soylentnews.org/article.pl?sid=18/05/20/1737213)
Suspend-to-RAM works decently to avoid this, and to avoid it sucking the battery dry, Suspend-to-Flash can be used. Yes this will take some time for restoring RAM... but again, to avoid the user noticing that time, why not start the wakeup process when the user unlocks their car / opens a door?
On desktops and laptops, it Usually Should Just Work (tm). The general culprits for issues are proprietary graphics and wifi drivers as well as shoddy BIOSes with broken ACPI tables, but I never had to dig this deep.
For embedded systems, the situation is more complex, as the chipset needs to support it - suspend itself is not the problem in most cases, but wakeup is - for example, the Raspberry Pi does not have a dedicated interrupt (https://github.com/raspberrypi/linux/issues/1281). If you're working with an embedded chipset, your best bet is the manufacturer, they have to deal with that in the BSP.
lucky you - I have a laptop (GS65) where suspend-to-ram occasionally fails to unsuspend, even on windows
https://ecos.sourceware.org/ https://github.com/luvit/luvit
Sadly there is not a really big community around both of these.
I’d rather just put a normal Linux distro there, however, I’m not feeling like waiting 8 seconds every time I turn in my car.
Apple CarPlay is in the same boat requiring an MFi private certificate, and no way to provision a short lived cert like they do for iPhones.