500 TB in 1 or 2 TB drives is a lot of hardware. <complete back of the hand calculation> If we have 250 drives with a 1 000 000 hour mtbf, then (according to an exponential distribution), you've got around ~5% chance of a drive failure each week. Not huge, but worth noting. </ complete back of the hand calculation>
I'm absolutely not denying that you should have a dedicated admin to look after such a deployment. But by today's standards it's just not a lot of hardware anymore. And definitely not the size where you must spend a fortune on "platinum" support contracts that can easily cost as much (per year) as a fully fleshed out spare shelf...
FWIW, I'm personally running a few moderately sized storage clusters (the largest is ~200T, 3x3 MD1000) and we're seeing disk failures at a rate of 2-3 per year.
Sorry, but what a bunch of FUD.
Any seasoned sysadmin can build an array with such low requirements. It's a different story when you need high IOPS or extreme availability - but none of that was asked for here.
Wazoox listed the off the shelf parts that you need, from there it's a matter of being able to operate a screwdriver and configuring your favorite RAID controller or soft-raid.
Of course you can double-up and buy the feel-good solution from a storage-vendor (DELL MD1000 would be the standard in this range). But in this case it doesn't seem worth to pay a markup for essentially the same hardware.