News for hackers. Stuff that matters.
Re:Esprit Board for Exploring ClojureScript on ESP32 Processors by prashnts on Wednesday June 03, 2020 @09:55AM (#23403362)
I was also curious, and from their Design repository:

> Note: You don't need to use this particilar board to run ClojureScript.

> Any ESP32 WROVER with 8 MiB SPIRAM is capable of running a ClojureScript REPL

https://github.com/mfikes/esprit-board/#esprit-board

I also looked at the schematics, which is your standard ESP devboard layout.

Edit: I'm not an expert, but have used tons of ESP based dev boards so there are a couple very frequent issues I've observed. Usually I have had trouble if the USB-UART chip is not wired correctly or doesn't reset quick enough. Lower baud rate makes it work. Also, the GPIO numbers on silk screen may not be correct, so double check those.

There are no comments on this comment yet.