News for hackers. Stuff that matters.
Re:Power tool manufacturers and who owns them by mturmon on Tuesday May 19, 2020 @06:15PM (#23240939)
I don't think a miter saw is a good place to economize unless you're doing only un-demanding work (e.g. rough framing). You really want it to keep a square adjustment and to have zero play. And it's a tool you might use a lot for a long time.
Re:Power tool manufacturers and who owns them by starpilot on Tuesday May 19, 2020 @07:36PM (#23241609)
Do you have any experience with cheap (<$200) miter saws?
Re:Power tool manufacturers and who owns them by mturmon on Tuesday May 19, 2020 @09:45PM (#23242452)
I have a 10" Delta that's about $160. It's not a slider. It advertises as compound, but setup is not repeatable, so I only use it for 90 degree cuts. (Perfect example of a "feature" that turns out to be useless in practice.) I have used it for rough carpentry and it's perfectly OK for that.

I also make furniture and do finish carpentry (DIY, not for sale), and that miter saw can only be used for rough cutoffs in such work. I have to do all final cuts on the table saw with a sled or a miter jig. So in truth, the miter saw is 90% useless for that work, because even awkward rough cuts on long stock can be done very quickly with a hand saw - just a basic Japanese-style pull saw that costs about $20.

Some of the Tacklife saws that are about $200 are sliders as well as compound miter. I'm skeptical that you can do anything more than rough carpentry on such a machine, because the slide mechanism introduces even more play. Of course, I haven't used the saw.

One of the merits of using machines in the shop (as opposed to hand tools) is that a quality machine is repeatable and predictable. You can't allow a 44 degree miter or a cut that's 1/16th too short in finish carpentry, so you can't use a mediocre miter saw.

The reason you can't ever be making 44 degree miters is that you may have already milled that piece to final dimensions in width and height, and a mistaken cut will require repeating all that work. In fact, such a mistake might not be recoverable if you were trying to achieve a grain match in un-painted work.

Many of the above factors are not relevant if you really just want to do basic framing!

Re:Power tool manufacturers and who owns them by starpilot on Tuesday May 19, 2020 @10:59PM (#23242871)
What really is "basic framing"? I'm thinking of build a rectangular desk with a rectangular "apron" of 2x4's for stiffness. Would this be along those lines?
Re:Power tool manufacturers and who owns them by mturmon on Tuesday May 19, 2020 @11:43PM (#23243092)
I mean like framing a house, shed, or garage with 2x4s. Not furniture!

If you have ever built a picture frame that you intend to hang on a wall and have people look at, you will know how hard it is to get good miters off a "just ok" miter saw.