News for hackers. Stuff that matters.
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by ac29 on Monday April 20, 2020 @01:29AM (#22921377)
Er, that's in the first sentence. What could be said a little more clearly is that the frequency 90.1 is actually the channel 90.0-90.2 since the convention is to tune to the center frequency. A convention of tuning to the lowest or highest frequency of the channel would be equally valid - its just not how its done.
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by jeffdavis on Monday April 20, 2020 @01:53AM (#22921491)
If you tune to the lowest frequency in the channel, wouldn't that be bad because it's on the border with the channel just below it? Tuning to the center of the channel seems like the only sensible thing to do, it's not just a convention. Or am I way off here?
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by ac29 on Monday April 20, 2020 @02:14AM (#22921592)
All I mean is that in the modern digital world, there is no difference between a channel being defined as 90.0 + 200kHz, 90.2 - 200kHz, or 90.1 +- 100kHz. "Tuning" isn't even really a thing in modern SDR receivers that can receive a huge band all at once (it is, but more as a UI convention than an analog necessity).
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by baddox on Monday April 20, 2020 @02:14AM (#22921591)
I assume the convention applies to both receivers and transmitters.
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by gugagore on Monday April 20, 2020 @02:13AM (#22921589)
This is probably just splitting hairs, but I don't think it is equally valid. Compared to the channel width, the center frequency is known / required to be set much more precisely. You could wiggle around by the bandwidth by 100s of Hertz and maybe lose some fidelity, or get some interference from neighboring channels, but you can't say the same for the center frequency.
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by jaywalk on Monday April 20, 2020 @01:58PM (#22926499)
It used to be relatively common for FM radio stations to run at over 100% modulation because it would allow them to be "louder" than the competition. Obviously this is illegal because it results in "spilling over" the assigned frequency band. But it absolutely was a thing.
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by ac29 on Monday April 20, 2020 @02:20AM (#22921618)
Only by convention though. The radio systems I use have a configurable channel width and center frequency - there are only so many legal options. Center frequency is just a convention though - a 100kHz channel being defined as being bounded by (freq + 50kHz, freq - 50kHz) is no more logically valid than (freq, freq + 100kHz) or (freq, freq - 100kHz).
Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by gugagore on Monday April 20, 2020 @03:21AM (#22921860)
What I'm saying is that the filter that shapes the bandwidth (on either Rx or Tx) is not a brick-wall filter. The channel width isn't exactly as stated, because there's a gradual roll-off.

If I misspecified the bandwidth, I can still tune into and broadcast at the right frequency. It's not just a convention, it follows how the transmitted and received signals are actually processed. I do not think it's more logical because setting the center frequency and setting the bandwidth of the baseband signal are two independent operations. Conceptually, they are orthogonal concepts. So it's logical to specify them in an orthogonal basis. Choosing another basis, as you're saying, works. But the current "convention" is more than just a convention. It's the natural choice.

If I take my FM radio and take it somewhere that uses different channel spacing, I can still tune it to the advertised frequency. That would not be the case with what your proposing.

Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by reaperducer on Monday April 20, 2020 @03:12PM (#22927243)
What could be said a little more clearly is that the frequency 90.1 is actually the channel 90.0-90.2

Not strictly. The main channel is 90.1. But many FM stations have sideband channels for various audio and data services, like reading books and newspapers to the blind.

Re:Why Do FM Frequencies End in an Odd Decimal? (2015) by SamReidHughes on Monday April 20, 2020 @10:16PM (#22931185)
After reading the whole article, I was still wondering why they didn't just put the center of the frequencies on the even numbers. Then I realized that's not the order in which they decided what to do.