Re:Company threatens to sue volunteers who 3D-printed valves...
by jagger27 on Tuesday March 17, 2020 @09:05PM
(#22612534)
> So the regulatory costs must be financed.
Absolutely. Why does the "financing" in this case have to go through a hospital's purchasing department? The obvious reason for why they charge such incredible amounts per unit is because they can. If there was any amount of competition or marketplace for it, it would be cheaper. There clearly isn't.
Explain to me how this way of doing things is not holding the public hostage.
Re:Company threatens to sue volunteers who 3D-printed valves...
by tomrod on Tuesday March 17, 2020 @09:14PM
(#22612598)
> I seriously doubt any critical medical part can be made for $1.
Seems like these things that were 3D printed could be. At least at a marginal cost.
Re:Company threatens to sue volunteers who 3D-printed valves...
by gentleman11 on Tuesday March 17, 2020 @09:42PM
(#22612755)
A few failures is a lot less deadly than what is happening in Italy right now
Each part is traceable from all raw materials to finished product
Each part is manually tested/calibrated
Each part may be tested with non-destructive testing (x-ray, ultrasound, dye crack inspection etc)
For every lot of parts, several parts will be tested destructively
Each part comes with liability, so the manufacturer will likely purchase liability insurance
Also, the regulatory costs are paid years in advance of a single unit being sold. Once the device is approved (that is, if it's approved at all), the units are sold slowly over years. So the regulatory costs must be financed.