Re:3D printed door handle developed in effort to reduce spre...
by bmarotta on Tuesday March 17, 2020 @01:50PM
(#22607790)
It doesn't look like it helps much...
[ Parent
| on HN ]
Re:3D printed door handle developed in effort to reduce spre...
by defterGoose on Tuesday March 17, 2020 @02:25PM
(#22608288)
Yeah, that type of handle is already a lever that you can use with your forearm. The motion is a little awkward, but it's free.
Re:3D printed door handle developed in effort to reduce spre...
by unwind on Tuesday March 17, 2020 @03:27PM
(#22609169)
But if the door opens towards you, it's really hard to pull on the handle with your forearm and this would provide something to hook your arm around for leverage.
Re:3D printed door handle developed in effort to reduce spre...
by defterGoose on Tuesday March 17, 2020 @04:04PM
(#22609664)
Hence the awkward part. It's not impossible.
Re:3D printed door handle developed in effort to reduce spre...
by HenryBemis on Tuesday March 17, 2020 @02:07PM
(#22608051)
And at a cost of €40 per pair it's a no-no. I think they will gain more from the free promo they will get from media/clicks than actual sells of the specific handle.
Re:3D printed door handle developed in effort to reduce spre...
by outworlder on Tuesday March 17, 2020 @03:02PM
(#22608818)
> And at a cost of €40 per pair it's a no-no
What the...
It probably cost less than a dollar to print these.
EDIT: Yep. Just added one to the slicer. $1 if you are paying about $25 per filament, which is on the expensive side. It would cost me about half as much.