Re:High-density hybrid powercapacitors: A new frontier in th...
by jacquesm on Tuesday March 10, 2020 @01:51PM
(#22537699)
I've worked with capacitors that were designed to dump their charge in a few us. You really do not want to mess with that stuff without proper precautions, nothing scares me more than a couple of hundred volts power source with an Ri too low to measure. You need to forcibly restrain your cabling or it will jump all over the place during a discharge.
Re:High-density hybrid powercapacitors: A new frontier in th...
by mikevp on Tuesday March 10, 2020 @06:02PM
(#22540271)
Heh... Recalling a demonstration by an EE prof way back when. He had the bank of capacitors charging up on his desk, and was writing on the blackboard the equations of how much energy was stored. Hand raised in the back of the room. "Uh, Dr. Miagawa, I think you slipped a decimal point there." Prof looks over his work again, says "Oh, dear" unplugs the charger and backs away. He tapes two meter sticks together with a screwdriver on the end to discharge his little electrobomb. WHAMO, screwdriver vaporizes.
I'm pretty much convinced this was not a mistake, it was a "Be really CAREFUL with this stuff!" object lesson.
While they look fairly harmless, one should also never forget that capacitors are the most dangerous part of any electric circuit; they don't become safe if power is off and they have no limit to their current other than "what the wire can do", which is usually northwards of "the wire evaporates".
I've experienced various caps burn their legs and solderpoints in less than a millisecond without warning once a short was realized. And on top of that, the huge currents running through wires not intended for that will usually cause quite a bit of inductive backlash in nearby components.