Re:I made my own PCBs with a 3D printer
by HeWhoLurksLate on Saturday February 15, 2020 @02:04PM
(#22337178)
Seconding KiCAD. Their software is fairly intuitive- especially if you're used to Linux- and it's super helpful for making sure that your designs are logical and stuff, and you can also use it to figure out how to best breadboard your designs as well.
[ Parent
| on HN ]
Re:I made my own PCBs with a 3D printer
by StavrosK on Saturday February 15, 2020 @02:07PM
(#22337200)
I disagree and think saying it's intuitive is doing people a disservice. It's not intuitive at all, but it's more intuitive than the alternatives and it won't take you very long to learn how to use it.
If you don't get it immediately, don't worry, that's normal. Just watch some tutorials and you'll be good to go in a few hours.
Re:I made my own PCBs with a 3D printer
by HeWhoLurksLate on Sunday February 16, 2020 @02:14PM
(#22343229)
Okay, you're right. I'd forgotten that I'd A) had a failed start with it and B) only gotten past that once I had to use it for a school project. That being said, once you figure it out, it's really powerful. It just takes a bit to get there, and I'd forgotten the beginning of my learning curve.
Sorry for the confusion, and thank you for reminding me of how hard it was for me personally to start.