News for hackers. Stuff that matters.
Re:Ouster's new digital Lidar – 128 beams, ultra-wide view by derek_frome on Monday January 06, 2020 @02:17PM (#21972149)
This is the spec for a cold start. If you give it a warm start, you can operate it much lower than -20C! For instance, it's being used in underground mines in Scandinavia without issue.
Re:Ouster's new digital Lidar – 128 beams, ultra-wide view by Y-bar on Monday January 06, 2020 @03:32PM (#21972973)
Scandinavian mines are all well above the freezing point below ground. (+2 - +5C)

From a pure temperature point of view mines are very easy with a known operating temperature and low fluctuations.

Re:Ouster's new digital Lidar – 128 beams, ultra-wide view by agoodthrowaway on Monday January 06, 2020 @03:13PM (#21972747)
The issue will not be at cold but at high temperature. VCSELs have very poor efficiency at high temperature and it’s possible to operate them where increasing current reduces light output. In a vehicle application the temperatures are very high and humidity can also be very high and condensing.
Re:Ouster's new digital Lidar – 128 beams, ultra-wide view by apacala on Monday January 06, 2020 @07:24PM (#21975258)
Ouster CEO here.

This couldn't be further from the truth. You can design the VCSEL cavity and top and bottom mirrors for peak efficiency at any temp, including very high temps. I wonder what we did...

Compared to the side emitter diode lasers used in legacy spinning lidar, VCSELS are cheaper, more efficient, more reliable, longer life, and better quality light sources to boot.

Re:Ouster's new digital Lidar – 128 beams, ultra-wide view by agoodthrowaway on Monday January 06, 2020 @09:11PM (#21976060)
Unfortunately the gain falls as function of temperature so you also get a lot less light and you have to pump harder (more current). So while it’s possible to somewhat compensate somewhat with the mirrors the device still has this behavior at high temperatures as the device self heats. This behavior is widely documented in the literature.

VCSELs have a smaller current aperture and the current density is higher than in an edge emitting laser. As the reliability is a function of the junction temperature and the current density, VCSELs operating at high temperatures have significantly reduced lifetime compared to an edge emitting device due to the high current density.

See for example slide 5 which shows how lifetime scales as a function of temperature and current density. For high reliability your devices need to have low current density.

http://www.ieee802.org/3/NGAUTO/public/adhoc/Kropp_NGAUTO_03...