Re:Show HN: USB PD Stand-Alone Sink Controller
by oxplot on Wednesday October 16, 2019 @06:02PM
(#21276420)
> I find the other comment about a programmable output voltage in 50mV increments a little amusing
To clarify, when you program the chip, you set a voltage with 50mV resolution and a lower and upper percentage bounds that you'll accept. The minimum percentage is 5%. So for instance, at 5V, you can't narrow down the range to less than 0.5V (4.75-5.25v).
Re:Show HN: USB PD Stand-Alone Sink Controller
by sokoloff on Wednesday October 16, 2019 @08:15AM
(#21269526)
Voltage refs are more typically 2 orders of magnitude better than that.
Re:Show HN: USB PD Stand-Alone Sink Controller
by userbinator on Wednesday October 16, 2019 @08:26AM
(#21269606)
Better references, yes, but 0.25% is typical of a cheap reference like a '431.
https://news.ycombinator.com/item?id=12618406
I find the other comment about a programmable output voltage in 50mV increments a little amusing, since 50mV of 5V is 1% and of 20V is 0.25%. To maintain the former level of regulation over changing loads would already require a very expensive and powerful supply with remote sense, while the latter is basically voltage reference territory.