News for hackers. Stuff that matters.
Re:The Celera 500L aircraft may fly soon by walrus01 on Friday June 07, 2019 @11:08PM (#20130384)
Long, straight wings resembling a glider and flying slower is a combination for better efficiency. Look at the wings on the long wingspan, 30 hour endurance version of an RQ9 reaper for instance. Or the wings on a U2, or Global Hawk.

The PC12 has speed to destination as a design criteria, and enough thrust to take off from runway length at small airports. If you remove those two constraints and say you don't care about raw speed so much, and it'll always fly from fields with 6500+ ft runways, that opens up new possibilities in design for long endurance.

Studying the design of the rutan Voyager, take a look at the wing length/shape and the 11,000 ft takeoff roll. That's one end of the extreme deep end of design possibilities. This is sort of a compromise somewhere in between.

The use of a diesel engine tells me that somebody cares about squeezing the very best kilojoule per kilogram ratio from a liquid fuel.

Re:The Celera 500L aircraft may fly soon by bayesian_horse on Saturday June 08, 2019 @02:39AM (#20130993)
The article mainly mentions kerosene-powered engines.

Is diesel more efficient on a per-kilo basis than kerosene? I always thought kerosene packs a bigger punch so you can carry less of it for the same distance.

Also if the plane is intended to fly both that high/slow and that low/slow that probably informs the wing choice. Less air resistance and lift up there.

Re:The Celera 500L aircraft may fly soon by walrus01 on Saturday June 08, 2019 @03:15AM (#20131086)
According to this, diesel is 45.6MJ/kg

Jet fuel is 43MJ/kg

https://en.m.wikipedia.org/wiki/Energy_density

A big part of it has to be how much is lost to heat, an internal combustion engine is far from efficient... But then again neither is a turbine.

Re:The Celera 500L aircraft may fly soon by dusbajd on Saturday June 08, 2019 @09:57AM (#20132394)
Hydrocarbons have very similar energy/mole and therefore energy/volume, energy/mass ratios.

This relationship breaks down for very short HC (methane, basic alcohols).

Differences in effective energy density result from the combustion cycle used: Otto is better than Diesel for the same compression ratio, but you can’t easily get high compression ratio w/ Otto. Therefore Diesels are, typically, more efficient.

However, if you use methane (high compression) in an Otto cycle with turbo compounding, you’ll probably beat diesel. But then you have NOx emissions

Re:The Celera 500L aircraft may fly soon by dsfyu404ed on Saturday June 08, 2019 @08:35AM (#20132064)
Kerosene, diesel, jp8, etc. are all basically the same from a power density point of view. It's what you burn them in and how you burn them that matters.
Re:The Celera 500L aircraft may fly soon by dusbajd on Saturday June 08, 2019 @10:15AM (#20132492)
Hydrocarbons have very similar energy/mole and therefore energy/volume, energy/mass ratios.

This relationship breaks down for very short HC (methane, basic alcohols).

Differences in effective energy density result from the combustion cycle used: Otto is better than Diesel for the same compression ratio, but you can’t easily get high compression ratio